لذت ماهیگیری

These are the bits needed for all three types of rig. (Pop-up, Snowman, Bottom bait)

Begin by removing approximately 5 inches, 13cm of the braid coating, for 15-16mm bottom and pop-up rigs, a little more for snowman rigs. Tie an over hand knot, to form the hair and hold a hook bait stop.   

Using a bait needle, thread the hook bait(s) onto the hair.

Add a boilie stop, to keep the bait on the hair.

Thread a micro ring onto the hook length, and secure in position almost an inch, about 2cms away from the bait for bottom & snowman rigs, with an over hand knot. 

Thread a Sz 8 Fox LS pattern hook through the micro ring. I have found this blow back style ring attachment increases the freedom of the bait, and helps the hooking potential of the rig.

Take the loose end of the hook link, and thread through the eye of the hook, from the top, ready to begin a knotless, knot.


Working away from the eye of the hook, make 6 turns with the hook link material around the hook shank, and thread the loose end back through the top of the eye. 

Tighten the hook link to complete the knotless knot.

Cut a section of shrink tubing, about an inch, 2.5cm long.